GRAPHTEC FC7000-160 - How to Replace the Y-Relay Board

FC7000-UM-251-9370 6-19
6. DISASSEMBLY AND REASSEMBLY
6.2.8 How to Replace the Y-relay Board
How to detach the Y-relay board
(1) Detach the center cover (see Subsection 6.1.3).
(2) Remove the two plastic rivets attaching the fl exible cable holding plate.
Plastic rivet
Flexible cable holding plate
(3) Disconnect all the cables from the Y-relay board.
(4) Remove the two M3L35 binding head screws attaching the Y-relay board.
M3L35 binding head screw
(5) Detach the Y-relay board from the Y-slider.
How to reinstall the Y-relay board
(1) Reattach the Y-relay board in the reverse order in which it was detached.