FC7000-UM-251-9370 6-14
6. DISASSEMBLY AND REASSEMBLY
How to reinstall the pen block
(1) Attach the pen block to the Y-slider.
(2) Fasten the two M4L6 binding head screws to attach the pen block so that there is
a gap of 10 mm
between the bottom of the pen block and the cutting mat. Perform a visual check to make sure that
the pen block is not mounted at an angle.
10 mm
(3) Reattach the other parts in the reverse order in which they were detached.
(4) Perform the pen force adjustment (see Section 7.3.7).
(5) Perform the auto registration mark sensor sensitivity adjustment (see Section 7.3.9).
(6) Perform the auto registration mark sensor offset adjustment (see Section 7.3.10).
To Next Page
Loading...
