FC7000-UM-251-9370 6-16
6. DISASSEMBLY AND REASSEMBLY
How to reinstall the Y-belt
(1) Shave 2 to 3 mm off both ends of the Y-belt until the wire comes out as shown below.
(2) Hang the Y-belt on both sides of the pulley.
(3) Attach both ends of the Y-belt to the Y-slider so that four notches of the Y-belt fi t into the Y-slider, then
attach with the Y-belt stopper plates removed in step (5) in the previous subsection.
M3L6 binding head screw
Y belt
Four notches of the Y-belt fi t into
the Y-slider.
(4) Attach the pen block (see Subsection 6.2.5).
(5) Reattach the other parts in the reverse order in which they were detached.
(6) Perform the Y-belt tension adjustment. (see Subsection 7.2.1).
To Next Page
Loading...
