FC7000-UM-251-9370 7-24
7. ADJUSTMENT
(9) Confirm the gap between the cross cutter dog and the cross cutter release plate.
(10) Press the F4 key to confirm the gap.
(11) Adjust the gap to a value in the range of 0 mm to 0.2 mm.
Press the UP or DOWN ARROW key to adjust the gap.
(1 unit = 0.05 mm)
Cross cutter dog
Cross cutter release plate
0 to 0.2 mm
(12) Press the F4 key to confirm the gap.
If the cross cutter dog presses on the cutter release plate too much, a position alarm error will be
displayed.
At this time reduce the C-CUTTER POS ADJ value.
(13) Press the ENTER key to store the setting.
(14) Turn off the power to exit from the adjustment menu.
To Next Page
Loading...
