4
Cut the Media.
Completed
3
Make various settings necessary for cutting the media.
●
Set the tool conditions depending on the media to be used.
*This function allows each preset condition to be memorized.
Tool setting :
Set the type of tool to be used.
Setting the Force :
Adjust the force for holding down the tool on the media.
Speed :
Adjust the tool moving speed.
Acceleration :
Adjust the tool acceleration.
Adjusting the Blade Length :
Adjust the length of cutter blade protruded out of the Cutter
plunger.
Offset :
Adjust the distance between cutter blade edge and center of Plunger.
Running Cutting Tests
P.2-34
Run Cutting tests after making each setting,
and check actual cutting conditions.
Offset is small Proper Offset is large
4
Output the created data into the Cutting plotter, and cut the media.
a
Output the data into the cutting plotter.
To stop on the way
Plotting operation will stop temporality when [STOP] key is pressed during
plotting.
P.3-12
b
Cut off the cut media. (Cross cut)
c
Remove the unnecessary portion of cut media, and affi x the
transfer sheet.
Transfer sheet
To Next Page
Loading...
