Flow of cutting operation
Introduced here as an example is the process for making a sticker by using the Cutting plotter and Marking
fi lm.
1
Create the data to be cut.
1
Prepare the data.
2
Set the Media.
3
Set the Condition.
2
Set the media on the Cutting plotter.
a
Check which point on the Cutting plotter the
paper should be set.
P.1-5
When Stock roller is mounted at front of main unit : Front loading
When Stock roller is mounted at rear of main unit : Rear loading
b
Place the media on Stock tray, and set the media.
(*The illustration shows the rear loading as a case.)
P.2-6
Setting the Push Roller
P.2-13
Fix the push rollers so that they are
positioned above both ends of media
and also grit rollers.
Push rollers
Stock rollers
<Front loading> <Rear loading>
Grit rollers
To Next Page
Loading...
