Settings and Measurement
3-19
Pulse
Sets the alarms for pulse input settings. These conditions can be set when they have been enabled
in the AMP settings.
Mode................................... Sets the same conditions as for "Condition Settings". Please refer to
"Condition Settings" in the previous section.
Lower - Level- Upper .......... Specifies the alarm level(s) for the conditions set in Mode.
Rising, Falling: Input a numeric value
Win In, Win Out: Input numeric values for the upper and lower levels.
Output ................................. Specifies the output channels for alarm generation (4 channels).
Logic
Sets the alarms for logic input settings. These conditions can be set when they have been enabled
in the AMP settings.
Mode................................... Sets the logic alarm conditions.
X: No alarm conditions set.
L: Enabled when the logic signal goes from High to Low.
H: Enabled when the logic signal goes from Low to High.
Trigger Settings
Start .................................... Specifies the trigger condition that must be met in order to initiate
measurement.
Off: No trigger is used. Instead, measurement is initiated by
pressing the START/STOP key.
Level: The start of measurement is triggered when the trigger
condition is satisfied.
Note:The Level condition is the level value set for the specified
channel range set (voltage, temperature).
Alarm: The start of measurement is triggered when the alarm condition
is satisfied.
Ext.: The start of measurement is triggered when a signal is input
from an external trigger terminal.
Specified Time:
Measurement starts at the specified time or when the time
trigger condition is satisfied.
If Repeat Trigger has been specified, the trigger action is as follows:
Triggered at: Off Absolute Time/On Relative Time
To Next Page
Loading...
