Settings and Measurement
3-23
yy
yy
y I/F Settings Window
The conditions for connecting to your computer are set here.
New Line Code ................... Sets the new line code. Select from CR+LF, LF, or CR.
Echo Back........................... This function can be specified as Enable or Disable.
USB ID Setting.................... Sets the ID number for the GL450. Specify a number from 0 to 7.
TCP-IP Settings .................. Sets the TCP-IP.
IP Address: Sets the IP address.
Subnet Mask: Sets the subnet mask.
Port Number: Sets the port number.
Gateway: Sets a gateway for the network connection.
CHECKPOINT
Be sure to restart the GL450 after settings have been made or changed. If the GL450 is used as is, the
computer connections may not be performed correctly.
USB PC Card Drive Mode
Inserting a PC card in the GL450's card slot and then connecting the GL450 to your computer via
USB enables the GL450 to be used as an external PC card drive.
(1) Insert the PC card in the GL450's card slot.
(2) Use the USB cable to connect the GL450 to your computer.
(3) Turn on the GL450's power supply while holding down the [START] key.
(4) A Removable Disk icon is displayed in your computer's "My Computer" window.
* This operation is recommended only for those computers running Windows 2000 or Windows XP.
* The PC card cannot be replaced when the GL450 is being used as a removable disk.
Setting Selections available Setting method
New Line Code CR+LF, LF, CR ENTER→Select→ENTER
Echo Back Enable, Disable ENTER→Select→ENTER
USB ID 0 to 7 ENTER→Select→ENTER
IP Address Numeric setting ENTER→Select→ENTER
Subnet Mask Numeric setting ENTER→Select→ENTER
Port Number Numeric setting ENTER→Select→ENTER
Gateway Numeric setting ENTER→Select→ENTER
To Next Page
Loading...
