GRAPHTEC GL840 - Page 151

3-75
CHAPTER 3 Settings and Measurement
(4)-5 Other settings
Set the network-related settings in the other settings.
New Line code
Species the line feed code.
Selection item Description
CR+LF Starts a new line with CR+LF code (default value).
LF Starts a new line with LF code.
CR Starts a new line with CR code.
FTP client settings
This is used to perform the FTP server setting of backup destination.
(1) (2) (3) (4) (5) (6) (7) (8)
Description
(1) FTP Server Enter the domain name or IP address of the FTP server. (Up to 127 characters)
(2) User Name Enter the user name of the FTP account. (Up to 31 characters)
(3) Password Enter the password of the FTP account. (Up to 31 characters)
(4) Port Number Enter the port number used for FTP. (0 to 65535)
Set the following according to the encryption method.
Off: 21
Explicit: 21
Implicit: 990
(5) PASV Mode Make the PASV mode setting.
ON : Should be set for communication with an external FTP server in a rewall environment.
OFF : Should be set for communication with an FTP server in a normal network environment.
(6) Encryption method Data sent and received by FTP is encrypted.
Off: Not encrypted
Explicit: Explicit mode. Encryption starts after the connection.
Implicit: Implicit mode. Encrypted communication is performed from the time of connection.
(7) FTP Server Connection Test Press right key to execute (Performs connection test to the FTP server.)
When the connection test is performed, a message is displayed. If connection cannot be
established, check the settings and perform the connection test again.
* If the connection test is passed, the following message is displayed.
(8) Recorded le when backup is
successful
When backup to the FTP server is successful, you should be selected "Leave" or "Delete"
the captured le. By setting to "Delete", the SD CARD can have enough capacity and can
capture for a long time.