28 K2 Storage Cabling Guide 03 September 2009
Chapter 2 Cable K2 devices
Cable Gigabit Ethernet switch
As directed by the system diagram for your K2 SAN’s level, cable the switch or
switches for your K2 SAN using the instructions in this section.
• “3400cl HP GigE switch for basic K2 SAN” on page 28
• “3400cl HP GigE switch for redundant K2 SAN” on page 29
• “2900 HP GigE switch for basic K2 SAN” on page 29
• “2900 HP GigE switch for redundant K2 SAN” on page 30
• “2900 HP GigE switch for basic nearline K2 SAN” on page 30
• “2900 HP GigE switch for redundant nearline K2 SAN” on page 31
3400cl HP GigE switch for basic K2 SAN
These cabling instructions apply to the following:
• HP 3400cl series Gigabit Ethernet switch on a basic (non-redundant) online K2
SAN.
To the media ports make one connection from each K2 Media Client or other iSCSI
client and two connections from the media server.
To the control ports make a connection from each K2 Media Client or other iSCSI
client, from the media server, from the RAID storage chassis, and from the control
point PC.
Media Ports
Control Ports
1 - 19 odd
2 - 20 even
To Next Page
Loading...
