03 September 2009 K2 Storage Cabling Guide 41
Dell 2950 LS for basic K2 SAN
Dell 2950 LS for basic K2 SAN
These cabling instructions apply to the following:
• Dell 2950 PowerEdge Server with four iSCSI interface adapters (TOEs) on a basic
(non-redundant) online K2 SAN.
Dell 2950 LS for redundant K2 SAN
These cabling instructions apply to the following:
• Dell 2950 PowerEdge Server with four iSCSI interface adapters (TOEs) on a
redundant online K2 SAN.
PCI 1
PCI 2
PCI 3
Gb 1Gb 2
To media (iSCSI)
ports on GigE switch
Fibre Channel
to RAID controller
To control port
on GigE switch
FTP: To control port
on GigE switch
PCI 1
PCI 2
PCI 3
Gb 1Gb 2
PCI 1
PCI 2
PCI 3
Gb 1Gb 2
A
B
To media (iSCSI)
ports on GigE switch A
Fibre Channel
to RAID controller 0
To media (iSCSI)
ports on GigE switch B
Fibre Channel
to RAID controller 1
To control port
on GigE switch A
FTP: To control port
on GigE switch A
To control port
on GigE switch B
FTP: To control port
on GigE switch B
Heartbeat
cable
(serial)
To Next Page
Loading...
