1
Introduction
About this Manual
Thank you for purchasing your new Kula Production Switcher. This installation manual will
help you through each stage of the physical installation of each component and advise you
of all relevant safety aspects. For user setup and configuration please consult the User
Instruction Manual. This manual covers Kula SDI, 12G-SDI and IP production switchers.
If you have any questions regarding the installation of your product, please refer to the
contact details listed at the rear of this manual.
3M/E 24 Xpt Comprised of:
1x K1X control surface
1x K1X control surface
1x KPX control surface
2M/E 24 Xpt Comprised of:
1x K1X control surface
1x KPX control surface
2M/E 16 Xpt Comprised of:
1x K1P control surface
1x KPP control surface
1M/E (19”) K5P Control Surface
Kula Mainframe
Note: Please note that all diagrams are for illustration purposes only and
may differ slightly from the purchased product. Grass Valley operates a
policy of continuous improvement and development. Grass Valley
reserves the right to make changes and improvements to any of the
products described in this document without prior notice.
To Next Page
Loading...
