25
Kula
Installation Manual
Mounting the Kula K5P 1M/E Control Surface into a 19” Rack
The Kula K5P 1M/E Control Surface can be mounted into a standards 19” rack.
1 Check that there is enough clearance for the connectors on the left side of the control
surface.
2 The control surface is fastened to the rack system using 4x M6 (1/4 inch) screws (screws
are available from rack suppliers).
3 Once fastened to the rack insert all of the connectors making sure that the external
PSUs do not hang from the side of the control surface, the PSUs have to be supported.
Note: The Kula K5P 1M/E control surface can also be mounted into a desk.
Desk Cutout Dimensions are on page 43.
To Next Page
Loading...
