34
Power Supplies
Control Surface External Power Supplies
Caution!
The Power Supplies have NO user serviceable parts inside and if one should become faulty,
it should be replaced immediately.
Control Surface External Power Supplies
The Kula Control Surface is supplied with 2 external 12V power supplies. One of the power
supplies powers the control surface, the other is for redundancy.
Caution!
The Power Supplies have NO user serviceable parts inside and are welded shut.
Do not attempt to open the power supply cases.
The power supply connector plug that connects to the control surface is a 4 pin “Snap and
Lock” type, care should be taken when connecting and un-connecting.
Note: Make sure that the mains power is turned Off before connecting the
PSU to the control surface.
Note: Do not allow the power supplies to hang freely from the control
surface. Make sure that the cables are not under any stress.
Snap and Lock type connector
To Next Page
Loading...
