GRASS VALLEY KULA - Connecting Control Surfaces Together

8
Cabling and Connections
Kula KPX, KPP, K1X, K1P and K5P Control Surface Connectors
Connecting a 2M/E Control Surface together
Below is a diagram showing how to connect a KPX and a K1X control surface together.
Connect the KPX control surface to the K1X control surface via the two “Comms” ports on
the right hand side of the control surface.
Kula KPX Control Surface
Kula K1X Control Surface
Kula K1X
Kula KPX
Note: Two “Comms” cables must be connected for correct operation!