7
Kula
Installation Manual
Non- touch screen monitor - once the external monitor is connected to the Kula control
surface, a USB mouse (shown above) is used to control the Kula menus on the monitor
screen.
Current Compatible Touch Screen Monitors
iiyama T2250-MTS
iiyama T2236-MSC B1 and B2
iiyama T2252-MTS
GeChic On-Lap 1502
ELO_1002L_1502L
ELO-2002L
Kula K1X and K1P Connections
The Kula K1X and K1P provides a 1 M/E Control Surface that works with the KPP Program
/Preview control surface. All power and comms to the control surface are provided by the
KPP control surface.
Diagram below shows the connector information for K1X and K1P Control Surface (RH Side)
(Note: The label below is on the underside of the control surface)
2x Comms Connection
Important Note:
NOT Ethernet, connections must be direct to the control surface-
Do Not use network switches or hubs.
CAT5 or above cables - crossover cables are Not suitable.
To Next Page
Loading...
