166
Appendix
Accessories
Stick with rotary proportional knob*
Order No. 4112
The rotary proportional knob integrated into the
stick is designed for use with non self-neutralising
functions, or to control a speed controller or simi-
lar special application.
Three-function stick switch*
Order No. 4113
The change-over switch integrated into the stick
has a centre detent and is designed to provide
three switched functions.
Can be used for auxiliary functions e.g. launch,
neutral and speed modes for high-speed and F3B
models, or as motor switch (OFF / half-throttle /
full-throttle) for F3E models.
Two-function stick switch*
Order No. 4143
Stick unit with single-pole change-over switch for
two switched functions. Ideal for auxiliary func-
tions; especially useful for competition pilots.
Kick button**
Order No. 4144
Pressing the button once turns the switch on;
pressing it again causes the button to spring out
to the “off” position again. The kick button can be
converted into a momentary button by removing
the latching spring; in this case the function re-
mains switched “on” only as long as the button is
held pressed in. We recommend having the kick
button installed by your local GRAUPNER Ser-
vice Centre.
* Units are installed by your local GRAUPNER
Service Centre. If the kick button, Order No.
4144, is to be used as Trainer transfer switch,
you must fi rst convert it to momentary action.
To Next Page
Loading...