Model memories
• • Model select Selects a free or occupied model memory 1 ... 30 47
• • Copy / Erase Erase a model memory
Copy one model memory to another memory
Copy from / to mc-22s, to a PC, or between an mc-22s, an mc-22 and / or an mx-22
Copy individual fl ight phases within one model memory
Back-up all models to a PC
47
• • Suppress codes Suppress functions from the multi-function select list within a memory; used for settings which are not to be alte-
red, or which are not required.
Note:
By default some menus are already suppressed. If necessary, move to the »Basic settings« menu and switch on
“Expert mode”, which activates all available menus, BEFORE you set up a new model.
49
Basic settings / Servos
• • Basic setup model Model name: max. 11 characters (letters, numbers, special symbols). Characters selected using rotary
control.
Stick modes, fi xed-wing model aircraft:
1: Elevator, rudder: left and throttle/brake, aileron: right
2: Throttle/brake, rudder: left and aileron, elevator: right
3: Aileron, elevator: left and throttle/brake, rudder: right
4: Throttle/brake, aileron: left and elevator, rudder: right
Stick modes, helicopter:
1: Pitch-axis, tail rotor: left and motor/coll. pitch, roll: right
2: Motor/coll. pitch, tail rot: left and pitch-axis, roll: right
3: Pitch-axis, roll: left and motor/coll. pitch, tail rotor: right
4: Motor/coll. pitch, roll: left and pitch-axis, tail rotor: right
Modulation: PCM20 for all “mc” or “DS mc” type PCM receivers (512 steps)
SPCM20 for all “smc” type SPCM receivers (1024 steps)
PPM18 for all PPM-FM receivers to date except DS 24 FM
PPM24 for “DS 24 FM” PPM FM receiver
Trim increment: Setting of increment size for all four digital trim levers, range 1 to 10
Receiver output: Interchange the receiver outputs. Swapping the outputs does not affect any other coupling
and mixer functions, servo settings etc., i.e. you do not have to adjust these settings if you
50
To Next Page
Loading...