Gree FLEXX Series Service Manual

GREE DC INVERTER HEAT PUMP CONDENSING UNIT
71
Model:FLEXX36HP230V1AO
Removal of front panel
NOTE: Before removing the front panel, make sure power is cut off.
Step
Picture
Work instruction
1. Remove the upper cover
plate.
 Unscrew the screws of the
upper cover plate with a
screwdriver.
2. Remove the front side plate.
 Unscrew the screws of the
upper and front side plate
with a screwdriver.
3. Remove the front grill.
 Unscrew the screws of the
front grill with a screwdriver.
4. Remove the front panel.
 Unscrew the screws that
connect the front panel to
the middle insulating board
and screws around the front
panel.

Gree FLEXX Series Specifications

General

Type	Heat Pump
Series	FLEXX
SEER	Up to 20
HSPF	Up to 10
Refrigerant	R410A
Heating Operation Range	-22°F to 75°F
Cooling Operation Range	5°F to 122°F
Operating Temperature Range (Heating)	-22°F to 75°F
Operating Temperature Range (Cooling)	5°F to 122°F
Energy Efficiency Ratio (EER)	Up to 12.5
Dimensions (Outdoor Unit)	Varies by model
Weight (Outdoor Unit)	Varies by model
Compressor Type	Inverter
Power Supply	208/230V, 1Ph, 60Hz
Noise Level	As low as 55 dB(A)