Greyline Instruments SLT32 - Page 42

Press È to Interval and Æ tothe Sec/Min column.Press È or Ç tosettheloggingtimeinterval.
Choose:
Press Æ toreturnto I
nterval andpress È to ResetLog? Toeraseallexistingdatainthelogpress
Æ to Y
es and È.TokeepexistingdataintheLogpress È from ResetLog? Ifyouhavemade
changestotheStartDate,TimeorInterval,thedataloggerwillautomaticallystartanew“session”.The
SLT32willdisplay“xxxxxHrs/DaysLeft”.
Fromthe xxxxxHrsLeft displaypress È to S
tore?Yes.Press Æ to Yes andthen È tosave
yourDataLoggingsetup,orpress È from S
tore? tocancelchangesmadeaboveandexitwithout
storingchanges.
FromtheDataLogging Store?Yes promptthemenuwillreturnto R
UNSTOPSETUP.Press Æ to
positionthecursorunder R
UN andpress È toactivatetheDataLoggertostart.TheSLT32willdisplay
SESSIONNO.x.Press È toreturnto DATALOGGING.
Note:GreylineLoggersoftwarecannotaccuratelycalculatetotalsfrom'event'basedlogfiles.Use
'trend'loggingformatiftotalsmustbecalculated.
Logging"Sessions"
Eachtimeyouselect STOP inthe DATALOGGING menu,theDataLoggerstoresthecurrentdatain
memoryasa"SESSIONNO"automaticallynumberedfrom"1"to"10".Ifyouresumeloggingby
selecting RUN,theDataLoggerwillreportthatanewloggingsessionisstartedandtitled"SESSION
NOxx".WhenyoudownloadtheloggerfilestoyourPCusingGreylineLoggersoftware,eachSession
willopenasaseparategraph/tabletitled"GreylineDataLogxx".
Important
:Ifyou STORE instrumentcalibrationchangesunderthe UNITS/MODE or CALIBRATION
menus, STOP thedataloggerandselect RUN againtostartanewloggingSessionwithyournew
calibrationvalues.
SLT32Level&FlowMonitor
ManualSeriesB.11
Page 42
30Sec
10Sec
5Sec
2Sec
1Sec
30Min
10Min
5Min
2Min
1Min