Need help?Do you have a question about the Greyline Instruments SLT32 and is the answer not in the manual?
General| Protection Rating | IP68 |
|---|---|
| Output | 4-20 mA |
| Power | 12-24 VDC |
| Power Supply | 12-24 VDC |
| Temperature Range | -20°C to 60°C |
| Operating Temperature | -20°C to 60°C |
Details on connecting AC and optional DC power sources to the instrument.
Setting a password to prevent unauthorized access to calibration menus.
Choosing measurement units (ft, in, cm, %) and operating modes (Range, Level, Flow).
Menu for selecting flume or weir type for open channel flow measurement.
Steps to determine MAX RANGE, MAX LEVEL, and MIN RANGE for level calibration.
Procedure for setting the minimum range (MinRg) for level measurement.
Procedure for setting the maximum range (MaxRg) for level measurement.
Steps to determine MAX RANGE, MAX LEVEL, and MIN RANGE for flow calibration.
Verifying the maximum range with the sensor installed.
Adjusting the 4-20mA output for offsets other than zero/full scale.
Setting damping to smooth display and output in turbulent conditions.
Suppressing false echoes from agitators, splashing, or turbulence.
Explanation of error messages like ILLEGAL MINRG, ILLEGAL UNITS, etc.
Troubleshooting issues related to display erratic behavior and ECHO LOSS prompts.
Faults causing incorrect target readings, like sensor aiming or buildup.
Troubleshooting interference from mounting, turbulence, or electrical sources.
Identifying how noise spikes enter the instrument via power, sensor, or output lines.
Recognizing symptoms like blinking displays or erratic relay trips due to RFI.
Using snubbers to limit voltage spikes from relay contacts.
Detailed specifications for the standard PZ32T sensor, including range, materials, and operating limits.
Worksheet for recording calibration data for Level mode.
To Next Page
