Greyline Instruments SLT32 - Configuration and Settings; Password Protection; Units and Mode Selection

PASSWORD
Thepassword(anumberfrom 00 to 99)preventsunauthorizedaccesstothe
CALIBRATION menu.
From RUN (scrollingdisplay)press Æ to PASSWORD.
Press Æ toplacethecursorunderthedigitsand È or Ç tochangethenumber
andthen Æ toproceedto CALIBRATION.
FactorydefaultPasswordis 00.Anewpasswordcanbestoredbygoing Æ to SPECIALFUNCTION
and È to NewPassword.
UNITS/MODE
Press Æ to UNITS/MODE,then È .Press Æ tomovethecursorundertherequiredmeasurementunits:
ft - feet
in - inches
m - meters
cm - centimeters
% - percent
Press È toRange LevelVolHrtFlow.Use Æ toselecttheoperatingmodeoftheSLT32.
R
ange
modedisplaysdistancefromthesensortothetargetorliquidsurfacelikeatapemeasure.
Rangemodeisusefultomeasuretheexactdistancefromthesensortothezerolevelduring
calibration,ortomonitor"outage"orfreespaceinatank.
L
evel modecanbeusedtomeasuretanklevelinlinearunits,or"Head"(heightofflow)inanopen
channelforcomparisonwithaflumemanufacturer'sflowtables.
Vol Volumemodedisplaystankinventoryinengineeringunitslikegallonsorliters.
Hrt HorizontalRoundTankmodesetstheSLT32tocalculateanddisplayvolumeunitsina
horizontalroundtank.
F
low modeisforopenchannelflowthroughaflumeorweir.
SLT32Level&FlowMonitor
ManualSeriesB.11
Page 8
DATA LOGGING
FLUME SELECTION
UNITS / MODE
ft in m cm %
Range Level
ft3 USG IG m3 L
Mx Vol xxxx.x ft3
Store? Yes
Vol Hrt Flow
ft3 USG USMG
IG IMG m3 L
s min hr d
PASSWORD: 00
PASSWORD: 00
PASSWORD: 01