Greyline Instruments SLT32 - Page 41

Press È to Start (time)and Æ topositionthecursorunderthetimecolumn HH/MM/SS (24hour
clockinHours/minutes/seconds,eg: 23:02:16)andthen È or Ç tosettheloggingstartTime.Press
Æ toreturntoStart.
Press È toIntervaland Æ tothe Sec
/Min column.Press È or Ç tosettheloggingtimeinterval.
Choose:
Press Æ toreturntoto Interval and È to ResetLog? Toeraseallexistingdatainthelogpress Æ
to Y
es and È.TokeepexistingdataintheLogpress È from ResetLog? Ifyouhavemadechanges
totheStartDate,TimeorInterval,thedataloggerwillautomaticallystartanew“session”.TheSLT32
willdisplay“xxxxxHrs/DaysLeft”.
Fromthe xxxxxHrsLeft displaypress È to S
tore?Yes.Press Æ to Yes andthen È tosave
yourDataLoggingsetup,orpress È from S
tore? tocancelchangesmadeaboveandexitwithout
storingchanges.
FromtheDataLogging Store?Yes promptthemenuwillreturnto R
UNSTOPSETUP.Press Æ to
positionthecursorunder R
UN andpress È toactivatetheDataLoggertostartatyourselectedstartDate
andTime.TheSLT32willdisplay SESSIONNO.x.Press È toreturnto DATALOGGING.
‘Event’basedTrendLogging
E
vent basedloggingstoresdatapointsonlywhenaHighorLowflowsetpointhasbeenreached.
Withcursorunder E
vent press È to HiAlmLoAlm . HiAlm willlogpoints above aselectableflow
rate,while LoAlm willlogpoints below aselectableflowrate.Positionthecursorunder HiAlm or
L
oAlm andpress È tothe At: prompt.Press Æ tothenumeralscolumnandpress È or Ç tosetflow
alarmloggingsetpoint.Press Æ toreturnto A
t:
SLT32Level&FlowMonitor
ManualSeriesB.11
Page 41
30Sec
10Sec
5Sec
2Sec
1Sec
30Min
10Min
5Min
2Min
1Min