Grizzly G0725 User Manual

Model G0725 (Mfd. Since 03/18)
-17-
6. Slide the fence bracket assembly over and
onto the support dovetails, as shown in
Figure 13.
Figure 13. Installing fence assembly.
Support
Dovetails
Fence Bracket
Assembly
8. Slide the fence forward until it contacts the
cutterhead guard. The guard should com-
pletely cover the cutterhead, as shown in
Figure 15.
7. Install the fence tilting handle by threading
the handle shaft into the bracket assembly,
as shown in Figure 14.
Figure 14. Installing the fence tilting handle.
Bracket
Assembly
Fence Tilting
Handle Shaft
Outward
Stop
Checking Outfeed
Table Alignment
The cutterhead knives MUST be level with the
outfeed table when they are at top dead cen-
ter (their highest point during rotation) or the
workpiece cannot be fed across the jointer safe-
ly.
To check the outfeed table alignment:
1. DISCONNECT JOINTER FROM POWER!
2. Place a straightedge on the outfeed table so it
extends over the cutterhead. For best results,
use a straightedge that will stand on edge
without having to be held in place.
3. Rotate the cutterhead under the straightedge
until one of the knives is at top dead center, as
illustrated in Figure 16.
Figure 15. Fence positioned over the jointer
tables.
Cutterhead
Guard
Jointer
Tables
Fence
—If your cutterhead knives brush the straight-
edge and move it slightly (
1
/8") forward and
back when you turn the cutterhead, then no
adjustments are necessary.
—If the knives fall below the straightedge
and do not move it, or if the knives lift the
straightedge and move it more than
1
/8", the
knives must be adjusted.
Figure 16. Illustration of a typical outfeed table
alignment setup.
Straightedge
Outfeed Infeed

Grizzly G0725 Specifications

General

Brand	Grizzly
Model	G0725
Category	Power Tool
Language	English