Grizzly G0725 User Manual

-34-
Model G0725 (Mfd. Since 03/18)
Symptom Possible Cause Possible Solution
Excessive snipe (gouge in the
end of the board that is uneven
with the rest of the cut).
1. Outfeed table is out of alignment with
the cutterhead.
2. Operator is pushing down on trailing
edge of the workpiece
1. Align cutterhead with outfeed table.
2. Reduce/eliminate downward pressure on that
end of the workpiece.
Cutterhead stops during
operation.
1. Cutterhead belt is damaged/broken. 1. Replace cutterhead belt.
Workpiece stops in the middle
of the cut.
1. Cutterhead is set lower than the
outfeed table.
1. Align the cutterhead knives with the outfeed
table at top dead center.
Chipping. 1. Knots or conflicting grain direction in
wood.
2. Nicked or chipped knives.
3. Feeding workpiece too fast.
4. Taking too deep of a cut.
1. Inspect workpiece for knots and grain; only
use clean stock.
2. Adjust one of the nicked knives sideways;
sharpen or replace blade.
3. Slow down the feed rate.
4. Take a smaller depth of cut. Never exceed
1
⁄8"
per pass. Reduce cutting depth when working
with hard woods.
Long lines or ridges that run
along the length of the board.
1. Nicked or chipped knives. 1. Adjust one of the nicked knives sideways;
sharpen or replace blade.
Uneven cutter marks, wavy
surface, or chatter marks across
the face of the board.
1. Feeding workpiece too fast.
2. Knives not adjusted evenly with each
other in the cutterhead.
1. Slow down the feed rate.
2. Adjust the knives so they are set up evenly
with the cutterhead.
Board edge is concave or convex
after jointing.
1. Board not held with even pressure on
infeed and outfeed table during cut.
2. Board started too uneven.
3. Board has excessive bow or twist
along its length.
4. Insufficient number of passes.
1. Hold board with even pressure as it moves
over the cutterhead.
2. Take partial cuts to remove the extreme high
spots before doing a full pass.
3. Surface plane one face so there is a good
surface to position against the fence.
4. It may take 3 to 5 passes to achieve a perfect
edge, depending on the starting condition of
the board and the depth of cut.
Overall, cut quality is poor;
inconsistent snipe problems;
or consistent difficulty feeding
workpiece.
1. Knives are out of alignment or
cutterhead height is not even with the
outfeed table.
2. Fence stops are set incorrectly.
3. Fence bracket parts are loose or parts
are misaligned.
1. Reset the knives to correct height and
alignment with cutterhead assembly.
2. Recalibrate the fence stops.
3. Check/tighten the fence bracket fasteners.
Cutting Operations

Grizzly G0725 Specifications

General

Brand	Grizzly
Model	G0725
Category	Power Tool
Language	English