-20-
G0803 (Mfd. Since 09/15)
4. Remove switch disabling key, as shown in
Figure 21.
5. Try to start machine with paddle switch. The
machine should not start.
— If the machine does not start, the switch
disabling feature is working as designed.
— If the machine does start, immediately stop
the machine. The switch disabling feature
is not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
Figure 21. Removing switch key from paddle
switch.
A properly tensioned blade is essential for mak-
ing accurate cuts, maximizing the blade life, and
making other bandsaw adjustments. However, a
properly tensioned blade will not compensate for
cutting problems caused by excessive feed rate,
hardness variations between workpieces, and
improper blade selection.
Optimal cutting results for any type of workpiece
are achieved through a combination of correct
blade selection, proper blade tension, properly
adjusted blade guides and other bandsaw compo-
nents, and using an appropriate feed rate.
Improper blade tension is unsafe, produces inac-
curate and inconsistent results, and introduces
unnecessary wear on bandsaw components.
Over-tensioning the blade increases the chance
of the blade breaking or wheel misalignment.
Under-tensioned blades wander excessively while
cutting and will not track properly during opera-
tion.
The method used to tension the blade is often
a matter of preference. This manual describes
two methods: the flutter method and the deflec-
tion method. Either method will help you properly
tension the blade. Experience and personal pref-
erence will help you decide which method your
prefer.
Tensioning Blade
Note: Tensioning the blade before the Test Run
was an approximate tension. The following proce-
dures fine-tune the blade tension.
To Next Page
Loading...
Need help?
General
