Grizzly G0803 User Manual

G0803 (Mfd. Since 09/15)
-41-
Symptom Possible Cause Possible Solution
Cut is crooked
or blade
wanders (blade
lead).
1. Feeding pressure too high or cutting
too fast.
2. Blade tension too loose.
3. Blade dull or damaged.
4. Inadequate blade support.
5. Blade too narrow for cut type.
6. Blade tracking incorrect.
7. Table loose.
8. Fence or miter slot out of alignment
with blade.
9. Blade guides or support bearing
incorrectly adjusted.
10. Tooth set uneven or teeth sharper on
one side than the other.
11. Wrong blade TPI.
12. Blade is following grain of wood.
1. Adjust feed rate and cutting speed as required.
2. Increase blade tension (Page 20).
3. Replace blade (Page 31).
4. Adjust upper blade guide as close to workpiece
as possible (Pages 22–23).
5. Use wider blade.
6. Adjust blade tracking (Page 17).
7. Tighten table trunnion mounting bolts or tilt
lock lever.
8. Align table and fence with blade (Page 24).
9. Adjust blade guide bearings and support
bearing for correct blade support (Pages 22–23).
10. Replace blade (Page 31).
11. Use a blade with fewer TPI.
12. Increase blade tension (Page 29).
Blade dulls
prematurely.
1. Wrong blade TPI.
2. Improper feed pressure.
3. Blade is twisted.
4. Blade is slipping on wheel.
5. Guides hitting teeth.
1. Use blade with correct TPI.
2. Use correct feed pressure.
3. Replace blade (Page 31).
4. Increase blade tension (Page 29). Clean
wheel tire.
5. Adjust blade guide bearings and support
bearing (Pages 22–23).
Backside
of blade
deformation/
cracking.
1. Feed pressure too high.
2. Blade tension too high.
3. Incorrect blade guide alignment.
4. Guides are worn.
5. Blade tracking too far back and hitting
lip of wheels.
1. Reduce feed pressure.
2. Adjust blade tension (Page 29).
3. Correct blade guide alignment (Pages 22–23).
4. Replace guides.
5. Adjust tracking (Page 17).
Sawdust
buildup inside
cabinet.
1. Clogged dust port. 1. Clean dust port.

Grizzly G0803 Specifications

General

Brand	Grizzly
Model	G0803
Category	Saw
Language	English