-22-
Model G1033/X/Z (Mfd. Since 02/19)
Workpiece
Inspection
Some workpieces are not safe to use or may
require modification before they are. Before cut-
ting,
inspect all workpieces for the following:
Material Type: This machine is only intend-
ed for workpieces of natural wood fiber
Attempting to use workpieces of any other
material that may break apart during opera-
tion could lead to serious personal injury and
property damage.
Foreign Objects: Inspect lumber for defects
and foreign objects (nails, staples, e
gravel, etc,). If you have any question about
the quality of your lumber, DO NOT
use it.
Remember, wood stacked on a concrete floor
can have small pieces of stone or concrete
pressed into the surface.
Loose knots can
become dislodged during operation. Large
knots can cause kickback and machine dam-
age. Always use
workpieces that do not have
large/loose knots.
Avoid using
with a high water content. Wood with more
than 20% moisture content or wood exposed
to excessive moisture (such as rain or snow),
will cut poorly and cause excessive wear to
the machine. Excess moisture can also has-
ten rust and corrosion of the machine
individual components.
Excessive Warping:
sive cupping, bowing, or twisting are danger-
ous to cut because they are unstable and
often unpredictable when being cut. DO NOT
use workpieces with these characteristics!
Minor Cupping: Workpieces with slight cup-
ping can be safely supported if the cupped
side is facing the table. On the contrary,
a workpiece supported on the bowed side
will rock during operation and could cause
severe injury from kickback.
Wood Types
The species of wood, as well as its condition,
greatly affects the depth of cut the planer can
effectively take with each pass.
The chart in
the figure below shows the Janka
Hardness Rating for a number of commonly
used species. The larger the number, the harder
the workpiece, and the less material should be
removed in any one pass for good results.
Note: The Janka Hardness Rating is expressed in
pounds of force required to embed a 0.444" steel
ball into the surface of the wood to a depth equal
to half the ball's diameter.
Species
Janka
Hardness
Ebony 3220
Red Mahogany 2697
Rosewood 1780
Red Pine 1630
Sugar Maple 1450
White Oak 1360
White Ash 1320
American Beech 1300
Red Oak 1290
Black Walnut 1010
Teak 1000
Black Cherry 950
Cedar 900
Sycamore 770
Douglas Fir 660
Chestnut 540
Hemlock 500
White Pine 420
Basswood 410
Eastern White Pine 380
Balsa 100
Figure 20. Janka Hardness Rating for some
common wood species.
To Next Page
Loading...
Need help?
General
