Growatt SPF 5000TL HVM User Manual

8
CAN
Communication protocol
Protocol 51
Protocol 52
.
.
.
.
.
.
Protocol 99
Note: When the battery type set to Li, the setting option 12, 13, 21 will change to display percent.
Note: When the battery type set as “LI”, the Maximum charge current can't be modified by the user. When the
communication fail, the inverter will cut off output.
Note: Any questions about communicating with BMS, please consult with Growatt.
3. Communicating with battery BMS in parallel system
If need to use communicate with BMS in a parallel system, you should make sure to connect the BMS
communication cable between the battery and one inverter of the parallel system. It’s recommended to connect to
the master inverter of the parallel system.
12
Setting SOC point back to
utility source when selecting
“SBU priority” or “Solar first”
in program 01
Default 50%, 6%~95% Settable
13
Setting SOC point back to
battery mode when selecting
“SBU priority” or “Solar first”
in program 01
Default 95%, 10%~100% Settable
21
Low DC Cut-off SOC.
If self-defined is selected in
program 5, this program can be
set up
Default 20%, 5%~50% Settable

Growatt SPF 5000TL HVM Specifications

General

Rated Power	5000W
Input Voltage	230VAC
Output Voltage	230VAC
Frequency	50/60Hz
Efficiency	93%
Battery Voltage	48V
Max. PV Array Power	6000W
Max. DC Voltage	450VDC
Number of MPPT Trackers	1
Max. Input Current	18A
Max. AC Output Current	21.7A
Max. Charging Current	80A
Max. Discharging Current	80A
Operating Temperature Range	-10°C to 50°C
Protection Degree	IP20
Cooling Method	Fan
Dimensions	330 x 485 x 135 mm
Communication	RS232, USB
MPPT Range	120-430VDC