Grundfos MAGNA1 C Series - 8.3 Connecting the pump to Grundfos GO Remote; Connecting to Grundfos GO Remote; 8.3.1 Using Grundfos GO Remote

English (GB)
25
8.3 Connecting the pump to Grundfos GO Remote
MAGNA1 single-head pumps are designed for infrared
communication (IR) with Grundfos GO Remote, while MAGNA1
twin-head pumps can also communicate via radio.
Before connecting to Grundfos GO Remote
To use Grundfos GO Remote together with MAGNA1 make sure
to have the following ready:
• For IR communication: A Grundfos GO add-on module, which
is available as an accessory. See section 6.8.5 Grundfos GO
Remote. See the separate installation and operating
instructions for the desired type of Grundfos GO setup.
• The Grundfos GO Remote app downloaded to your smart
device. Grundfos GO Remote is available in Apple App Store
and Google Play.
Connecting to Grundfos GO Remote
To connect to Grundfos GO Remote, do as follows:
1. For IR communication: Establish a connection between the
Grundfos GO add-on module and your smart device. See the
separate installation and operating instructions.
2. Open the Grundfos GO Remote app and select either IR or
radio communication depending on the pump type and chosen
communication method. Make sure to point Grundfos GO at
the receiver placed left or right to Grundfos Eye depending on
your pump model. See fig. 31.
Fig. 31 Establishing a connection between Grundfos GO and
MAGNA1 via infrared communication
8.3.1 Using Grundfos GO Remote
Fig. 32 Grundfos GO Remote dashboard
TM06 9081 3617TM06 7653 0718
IR
Plug-connected versions
Terminal-connected
versions
Min. 30 cm
IR
Max. 15 °
Max. 15 °
TM06 8584 0817
Pos. Description
1 Information about the connected product.
2
Grundfos Eye reflecting the current operating status of
the pump.
3
In a multipump system: Icon indicating if Grundfos GO
is connected to the master or slave pump.
When connected to a single pump: The field is empty.
4 The actual, measured head (pressure).
5 The power consumption of the pump.
6
Main menu. See section 8.3.2 "Status" menu,
8.3.3 "Settings" menu and 8.3.4 "Alarms and warnings"
menu.
7
"Disconnect": Disconnects Grundfos GO from the
pump.
"Refresh": Retrieves current data from the pump.
"Reports": Wizard creating a report with the pump's
current operating status and settings.
"Help": Guides you through the app.
When using Grundfos GO in a multipump setup and
choosing "system view", Grundfos Eye, pos. 2, fig.
32, will indicate the system's operating status and not
the status of the pump itself. See section
9.1.1 Multipump system operating indications.
3
2
5
6
7
1
4