Grundfos NBE Series - 6.1.1 Operating panels, HMI 200 and 201

6.1.1 Operating panels, HMI 200 and 201
1
2
3
4
5
TM082873
Pos. Symbol Description
1 Grundfos Eye: The indicator light shows the operating status of the product.
2 - Light fields for indication of the setpoint.
3 Up/Down: The buttons change the setpoint.
4
Communication:
The button enables communication with Grundfos GO and other products of the same type.
5
Start/Stop: Press the button to make the product ready for operation or to start and stop the product. Start: If
you press the button when the product is stopped, the product starts if no other functions with higher priority
have been enabled. Stop: If you press the button when the product is running, the product always stops.
When you press the button, the stop icon appears at the bottom of the display.
6.1.1.1 Setting the setpoint in constant parameter mode
The following applies for motors set to operate in Const. other val.
• Set the desired setpoint by pressing the Up or Down buttons.
The green light fields on the operating panel indicate the setpoint
set.
The following example applies to a pump or motor in an application
where a pressure sensor gives a feedback to the pump or motor.
The sensor has been set manually, and the pump or motor does not
automatically register a connected sensor.
Light fields 5 and 6 are activated, indicating a desired setpoint
of 116 psi (8 bar) with a sensor measuring range from 0 to 232 psi
(16 bar). The setting range is equal to the sensor measuring range.
116 (8)
232 (16)
0
psi
bar
TM068914
6.1.1.2 Setting the setpoint in constant curve mode
• Set the desired setpoint by pressing the Up or Down buttons.
The green light fields on the operating panel indicate the setpoint
set.
Example: In Constant curve mode, the motor output is between
minimum and maximum speed defined by Operating range.
27
English (US)