Appendix A
A.1. Installation in the USA and Canada
To maintain the cURus approval, the additional
information in this section must be followed.
Environmental enclosure ratings
According to UL 778/C22.2 No 108-14, pumps intended for outdoor
use must be marked enclosure type 3 and the product must be
tested at a surface temperature down to -31 °F (-35 °C). The MLE
Model J enclosure is approved for NEMA type 3 or 4 and is rated at
a surface temperature down to 32 °F (0 °C), thus it is only for indoor
use in UL 778/C22.2 No 108-14 pump applications.
The MGE, MLE Model K enclosure is approved for NEMA type
12 and is suitable for indoor use only.
For more information about ambient temperature during operation,
see the sections on operating conditions and ambient temperature.
EMC statements for USA
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own
expense.
MLE motors of the C2 emission category fulfill the limits of
Class A.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
MLE motors of the C1 emission category fulfill the limits of
Class B.
MLE motors of the C3 emission category can only be
used in industrial plants and public utilities in accordance
with FCC § 15.103(b) and ICES 003 § 1.5.1(c). In other
locations, MLE motors of the C1 or C2 emission category
must be used.
Canadian Interference-Causing Equipment Standard
MLE Model J complies with the Canadian ICES-003 Class B
specifications. This Class B device meets all the requirements of
the Canadian interference-causing equipment regulations.
L'appareil MLE Model J, est conforme à la norme NMB-003 du
Canada pour le matériel de classe B. Cet appareil de classe B
respecte toutes les exigences du règlement canadien s'appliquant
au matériel brouilleur.
MLE Model K complies with the Canadian ICES-003 Class A
specifications. This Class A device meets all the requirements of
the Canadian interference-causing equipment regulations.
L'appareil MLE Model K, est conforme à la norme NMB-003 du
Canada pour le matériel de classe A. Cet appareil de classe A
respecte toutes les exigences du règlement canadien s'appliquant
au matériel brouilleur.
Hot surface
The product might reach a surface temperature of 149 °F (65 °C),
therefore pay attention when operating the product.
The following marking is found on the product:
TM084167
A.2. Radio communication
For the USA and Canada
CAUTION
Radiation
Minor or moderate personal injury
‐ This equipment complies with FCC and ISED radiation
exposure limits set forth for an uncontrolled
environment. This equipment must be installed and
operated with a minimum distance of 8 inches (20
cm) between the radiator and your body.
This device complies with Part 15 of the FCC rules and
RSS210 of the IC rules.
Changes or modifications made to this equipment not
expressly approved by Grundfos may void the FCC
authorization to operate this equipment.
Operation is subject to the following two conditions:
• This device may not cause interference.
• This device must accept any interference, including interference
that may cause undesired operation of the device.
Pour les États-Unis et le Canada
CAUTION
Radiation
Blessures corporelles mineures à modérées
‐ Cet équipement est conforme aux limites d'exposition
aux rayonnements définies par la FCC et l'ISDE pour
un environnement non contrôlé. Cet équipement doit
être installé et utilisé à une distance minimale de 20
cm (0,66 pi) entre le radiateur et votre corps.
Cet appareil est conforme à la section 15 de la
réglementation FCC et à RSS210 de la réglementation IC.
77
Appendix A
To Next Page
Loading...
