7.25.26.5 Disabling a multipump system with Grundfos GO
1. Go to Assist.
2. Select Multi-pump setup and press Disable.
3. Press the Right button to continue.
4. Confirm the setting by pressing Send.
5. Press Finish.
7.25.26.6 Disabling a multipump system with the HMI 300 or
301 operating panel
1. Go to Assist.
2. Select Setup of multi-pump system.
3. Press the Right button to continue.
4. Press OK to confirm Disable.
5. Press the Right button to continue.
6. Press OK to confirm.
7.25.27 Description of control mode
The function is only available in the HMI 300 and 301 operating
panels.
The function describes each of the control modes available for the
product.
7.25.28 Assisted fault advice
This function provides guidance and corrective actions in the event
of product failure.
64
English (US)
To Next Page
Loading...
