Grundfos NBE Series - Control Functions and User Interfaces; User Interface Operation and Panels

8. Route the wires for the module through one of the cable glands.
TM084042
Model J
TM082869
Model K
9. Fit the CIM cover.
10. If the module is supplied with an FCC label, fix the label on the
terminal box.
FCC
TM084101
Model J
FCC
TM082870
Model K
11. Fit the terminal cover and cross-tighten the four screws to
3.7 ft⋅lb (5 Nm).
Make sure that the terminal box cover is aligned with
the orientation of the operating panel.
6. Control functions
6.1 User interfaces
WARNING
Hot surface
Death or serious personal injury
‐ Touch only the buttons on the operating panel. The
product may be very hot.
WARNING
Electric shock
Death or serious personal injury
‐ If the operating panel is cracked or perforated, replace
it immediately. Contact the nearest Grundfos sales
company.
You can change the settings by means of the following user
interfaces:
• HMI 200 operating panel
•
HMI 201 operating panel
4)
• HMI 300 operating panel
•
HMI 301 operating panel
4)
• Grundfos GO application.
4)
HMI without a radio module.
All settings are saved if the power supply is switched off.
26
English (US)