Grundfos NBE Series - 7.25.30 Factory settings

7.25.30 Factory settings
● Function is enabled.
❍ Function is disabled.
- Function is not available.
Settings NBE, NKE, NBSE, VLSE
NBE, NKE, NBSE Series 2000;
VLSE with Delta ρ sensor
Setpoint 67 % 58 %
Operating mode Normal Normal
Control mode Const. curve Prop. pressure
Date and time ● ●
Buttons on product ● ●
Controller (Controller settings)
T
i
0.5 0.5
K
p
0.5 0.5
Operating range
Min. 25 % 25 %
Max. 110 % 110 %
Ramps ❍ ❍
Ramp-up 1 second 1 second
Ramp-down 3 seconds 3 seconds
Number (Pump number) 1 1
Radio communication ● ●
Analog input 1 ❍
❍
12)
Analog input 2 ❍ ❍
Analog input 3 ❍ ❍
Grundfos Direct Sensor -
●
13)
Pt100/1000 input 1 ❍ ❍
Pt100/1000 input 2 ❍ ❍
Digital input 1 Ext. stop Ext. stop
Digital input 2 ❍ ❍
Digital input 3 ❍ ❍
Digital input/output 4 ❍ ❍
Predefined setpoints ❍ ❍
Analog output ❍ ❍
External setpoint funct. ❍ ❍
Signal relay 1 Alarm Alarm
Signal relay 2 Ready Ready
Limit 1 exceeded ❍ ❍
Limit 2 exceeded ❍ ❍
Limit 3 exceeded ❍ ❍
Limit 4 exceeded ❍ ❍
Standstill heating ❍ ❍
Motor bearing monitoring ❍ ❍
12)
VLSE with Delta ρ sensor has the sensor connected to an analog input.
13)
Not VLSE with Delta ρ sensor.
66
English (US)