Grundfos Oxiperm Pro OCD-162 - 7 Commissioning; Control Elements; Initial Display

English (GB)
33
7. Commissioning
This section includes information on how to start the system after
having installed all components.
The control elements are described. The navigation between the
menus is explained.
Section 7.5 Menu structure gives an overview of the menu
architecture.
7.1 Control elements
Fig. 30 Control elements
7.2 Initial display
The initial display is the first screen that appears after turning on
the system.
Fig. 31 Initial display
Warning
Only authorised service staff is allowed to
commission the system.
Before commissioning, check the hoses, connections
and pumps for leakages.
Check the system for installation faults.
Risk of burns due to the escape of chemicals from
faulty seals, valves, hose connections and lines.
Caution
Risk of corrosion damage to the main water line and
damage to property due to malfunctions resulting
from insufficient quality of the dilution water.
Pressure, temperature and drinking water quality
must comply with the system specifications.
Check the dilution water before and during
commissioning.
Note
We recommend that you install a gas warning device.
TM05 9279 4213
Button Function
[Esc]
Cancel command, exit menu, confirm alarm
message, return to previous menu
[Up]
Select previous menu item, set higher
numerical value
[Down]
Select next menu item, set lower numerical
value
[OK] Confirm menu selection
[Cal] Open calibration menu
[Man] Open manual dosing menu
Indicator LED Function Colour
[Alarm] Alarm Red
[Caution] Warning Yellow
[Cal] Calibration Yellow
[Man] Manual dosing Yellow
TM05 9282 4313
Pos. Message Description
1
example:
"prod. running"
Production status, see section
5.4.3 Production status
2
Solenoid valve relay
White
background
when inactive.
Black
background
when active.
HCl pump relay
NaClO
2
pump relay
Warning relay
Alarm relay
3
Relay of mechanical
ClO
2
dosing pump.
Mechanical pump
stopped. The symbol
is struck through.
4
Output for digital pump.
The height of the bar is proportional to
the actuating variable (0-100 %)
Digital pump stopped
The symbol is struck through.
5
Water meter
The height of the bar is proportional to
the flow (0-100 %).
6
example:
7.36 pH
pH value of the
sample water
Display value
is only
available with
connected
measuring cell.
7
example:
0.23 mg/l
ClO
2
concentration
8
example:
24.5 °C
Sample water
temperature
9 Progress bar if production is running
1
2
34
5
8
7
6
1 2
3
45
8
9
6
24.5 °C
0.23 mg/l
pH 7.36
prod. running
6