English (GB)
34
7.3 Navigation
Use the [OK] and [Esc] keys to navigate between the main menu
and the initial display.
Fig. 32 Display and control elements
Use the [Up], [Down], [OK], [Esc] keys to navigate in the main
menu and submenus.
The notation "main menu > commissioning > language" means:
1. Select "commissioning" in the "main menu" and press [OK].
2. Select "language" in the "commissioning" menu and press
[OK].
The notation "Enter the value XYZ" means:
1. Enter the value XYZ via the buttons [Up], [Down].
2. Confirm with [OK].
The menu dialogues shown are examples. The dialogues depend
on the settings made and the components connected.
7.4 Access codes
Three different access codes are assigned to all submenus. Each
code gives access to a defined area.
Operator code
By default, all operator menus are unprotected. The operator has
the possibility to define his own operator code.
Access is enabled for 60 minutes after entry of the code.
Service-user code
Some settings are reserved for trained service engineers (light
grey fields in the menu structure table, see section 7.5 Menu
structure). These settings are protected by the service-user code
2633. The service-user code is necessary for commissioning.
Access is enabled for 30 minutes after entry of the code.
Super-user code
Some settings are preset in the factory (dark grey fields in the
menu structure table, see section 7.5 Menu structure). These
settings are only accessible with the super-user code. The super-
user menus are not described in these operating and installation
instructions.
Factory-set reset code
The factory-set reset code 6742 is used to reset the system to the
factory settings.
TM05 9655 4213
To Next Page
Loading...
