English (GB)
41
7.15.4 Stroke length
"main menu > commissioning > dosing pump > stroke length"
Enter the stroke length. For a digital pump set 100 %. See also
section 5.9 ClO
2
pump type.
7.15.5 Maximum dosing flow
"main menu > commissioning > dosing pump > max. dosing flow"
Enter the maximum dosing flow, see section 5.6.9 Maximum
dosing flow (
Qmax
).
7.15.6 Dosing stop input
"main menu > commissioning > dosing pump > dos. stop input"
.
Set the polarity of the dosing stop input.
7.16 Relays
7.16.1 Warning relay
1. "main menu > commissioning > relays > warning relay"
2. Set the polarity of the warning relay.
7.16.2 Alarm relay
1. "main menu > commissioning > relays > alarm relay"
.
2. Set the polarity of the alarm relay.
7.17 Failure input
1. "main menu > commissioning > failure input"
.
2. Set the polarity of the failure input.
7.18 Operator code
7.18.1 Change
By default, all operator menus are unprotected.
1. "main menu > commissioning > operator code"
2. "change"
3. Enter the current operator code.
4. Enter the new operator code.
7.18.2 Delete
1. "main menu > commissioning > operator code > delete"
2. Enter the operator code.
7.19 Settings
All settings made during the commissioning can be saved.
7.19.1 Save
To save all settings:
1. "main menu > commissioning > settings > save"
7.19.2 Restore
To restore the settings saved previously:
1. "main menu > commissioning > settings > restore"
7.19.3 Factory reset
All settings will be restored to the factory settings.
1. "main menu > commissioning > settings > factory reset"
2. Enter the factory-reset code, see section 7.4 Access codes
stroke length
100 %
To Next Page
Loading...
