English (GB)
4
1. General information
1.1 Target group
These installation and operating instructions are intended for
authorised and qualified operating and service staff.
1.2 Purpose of this manual
These installation and operating instructions describe how to
install, commission, operate, maintain, repair, dismantle and store
the system.
1.2.1 Software version
These installation and operating instructions refer to the software
version v2.00.0.
1.3 Symbols used in this document
Information about possible residual risks can be found:
• on warning signs located at the installation site
• at the beginning of each section in this manual
• immediately before steps associated with a residual risk.
1.4 Notations used in this document
Display text in this document is set in quotation marks.
2. Safety instructions
2.1 Obligations
2.1.1 Service staff
Only authorised service staff are permitted to undertake
installation, commissioning, maintenance, repair, dismantling and
storage of the system. Appropriate technical expertise and
familiarity with the principles of measurement and control
technology are assumed.
Service staff are required to do the following:
• Read this manual thoroughly before commencing installation,
commissioning, maintenance, repair, dismantling or storage of
the system.
• Observe the recognised regulations for health and safety and
accident prevention.
• Wear protective clothing in accordance with the local safety
regulations when working with the system and with chemicals.
The protective clothing is supplied by the operating company
and stored in a dry place in the installation room.
2.1.2 Operating company
Owners of the building and operators of the system are obliged
to:
• Consider this manual to be part of the product and make sure
that it is kept clearly accessible in the immediate vicinity of the
system for the entire service life of the system.
• Provide the installation requirements specified by the
manufacturer (necessary water connections and fittings,
environmental conditions, electrical connections, protective
pipe for dosing line, audible or visual warning system for
alarms).
• The operating company has to elaborate a maintenance plan
depending on the on-site conditions and the specific
application of the system.
• Make sure that water lines and fittings are regularly checked,
repaired and maintained.
• Obtain official approval for storing chemicals, if necessary.
• Instruct operators in the operation of the system.
• Attach the labels supplied by the manufacturer at the
installation site so that they are clearly visible.
• Make sure the operator has received appropriate technical
training.
• Make sure that the regulations for the prevention of accidents
are observed in the installation location.
• Provide all operators and service staff with protective clothing
in accordance with the regulations for the prevention of
accidents: gloves, face mask, protective apron, breathing
apparatus, if necessary.
2.2 Intended use
Oxiperm Pro OCD-162 is a system for the discontinuous
preparation of a chlorine dioxide solution out of hydrochloric acid
(HCl, 9 %) and sodium chlorite (NaClO
2
, 7.5 %), and the
continuous dosing of this solution for water disinfection.
Warning
If these safety instructions are not observed, it may
result in personal injury.
Warning
If these instructions are not observed, it may lead to
electric shock with consequent risk of serious
personal injury or death.
To Next Page
Loading...
