Grundfos PHT A N - Operating Conditions and Wall Fixings

www.grundfos.co.uk
GRUNDFOS INSTRUCTIONS
11
6.9 Operating Conditions.
Electrical supply: 230 V +10 /-6%, 50 Hz
Electrical load:
Model
Power (Watts)
Full Load current (Amps)
PHT A-N130/PHT A-N230
28 W
0.10 A
PHT A-D125/PHT A-D225
440 W
1.90 A
PHT A-D150/PHT A-D250
900 W
3.30 A
PHT A-F125/PHT A-F225
440 W
1.90 A
PHT A-F150/PHT A-F250
900 W
3.30 A
PHT A-F180/PHT A-F280
1150 W
6.0 A
PHT A-T225/PHT A-V225
440 W
1.90 A
PHT A-T250/PHT A-V250
900 W
3.30 A
Quiescent All models
15 W
0.07 A
Pollution Degree: 3 Noise level: <70 dB(A) at full speed
Liquid temperature range: +1°C to +60°C Ambient temperature: From +1°C to 40°C
Relative humidity: 95% (non-condensing)
Usage: Indoor (Outdoor, subject to restrictions found)
Type of protection: Class 1 (earthed) equipment
Equipment type: Stationary, fixed equipment
Construction type: Fixed construction, no moveable parts
EMC Environment: B (light industrial, commercial and residential)
Inlet pressure max: PHT A N/D/V Models: See Chapter 8.1 – Float Valve adjustment
All other PHT A Models: Low pressure seat 2.5 Bar (as fitted)
Medium pressure seat 6.0 Bar (option only)
6.10 Wall Fixings.
All units must be mounted/stood in the vertical position.
The PHT A-N and PHT A-D units are suitable for wall fixing.
The wall fixing dimensions are given below.
Fig 5. – Wall fixing dimensions
Refer to the Product weight table also.