GRUNDFOS INSTRUCTIONS
8
6.0 General information.
6.1 Delivery and handling.
Except for the PHT A N unit all PHT A units are supplied from the factory
strapped to a wooden pallet suitable for handling by forklift equipment or similar.
The weight and size of the PHT A unit may require the use of proprietary lifting equipment to be
handled safely. Please observe the weight indicated on the packaging label before selecting
lifting method.
Do not stack items on top of the PHT A unit.
Do not drop the pallet/PHT A unit
6.2 Delivery inspection upon receipt.
The PHT A should be immediately unpacked and inspected.
Any damage must be reported to the supplier within seven days in writing or sooner.
It is important that this Installation and Operating manual is studied carefully before any
installation takes place. The installation and operation should also be in accordance with local
regulations and accepted codes of practice.
Under no circumstances should the unit be operated until correctly installed in the
system pipework and ensure that the controller cover and product cover are secured
in their appropriate positions.
6.3 Warranty.
1. The Grundfos warranty covers all defects within the PHT A originating from faulty
workmanship and/or materials for a period of two years from the date of installation or
thirty months from the date of dispatch from the factory, whichever is the shorter.
2. The warranty covers the replacement of any faulty parts and our labour cost to replace the
faulty parts. It does not cover the cost of removing, returning and refitting the PHT A unit or any
secondary losses arising from the failure.
3. Under no circumstances should faulty equipment be dismantled.
Failure to comply with this instruction could invalidate the warranty.
4. Defects arising from incorrect installation, water containing debris, or harmful chemicals,
inadequate electrical protection, faulty ancillary equipment, lightning or other circumstances
beyond our control, are not covered by the warranty.
6.4 Site storage on receipt.
It is strongly recommended once the PHT A unit has been delivered to site, that it is placed
immediately into a dust, moisture and frost-free area which has been secured to prevent
unauthorised interference. If this is not possible then the unit should be stored in an area which
is as near as possible to the ideal storage conditions as described above.
To Next Page
Loading...
Need help?
General
