Grundfos SMART Digital XL DDA 60-10 User Manual

English (GB)
49
* Depending on setting
Disch. valve leak
(Alarm)
• Leaky/dirty outlet valve. Dosing
medium flows back from the outlet
line into the dosing head and
moves the motor.
• Inlet pressure too high. Dosing
medium flows from the inlet line
into the dosing head and moves
the motor.
• Replace valve if necessary. See section
8.4 Perform service.
• Install screen in inlet line.
• Reduce inlet pressure. Observe section
4.1 Technical data.
Cavitation
(Alarm)
• Blocked / constricted / squeezed
inlet line
• Blocked/constricted inlet valve
• Suction lift too high
• Viscosity too high
• Cavitation moves the motor
• Enable "SlowMode". See section
7.6
SlowMode .
• Reduce suction lift.
• Increase inlet line diameter.
• Check inlet line and open isolating valve if
necessary.
Overheating
(Alarm)
• Motor is overheated • Reduce ambient temperature.
• Stop pump until motor cools down.
Service now
(Warning)
• Time interval for service expired • Perform service. See section 8.4 Perform
service.
Display in the
"Alarm" menu
Possible cause Possible remedy

Grundfos SMART Digital XL DDA 60-10 Specifications

General

Max Flow Rate	60 l/h
Max Pressure	10 bar
Control Type	Digital
Protection Class	IP65
Power Supply	50/60 Hz
Turn-down ratio	1:3000
Approvals	CE
Operating Temperature	0°C to +45°C