Fit the spring onto the quick release shaft, with
the narrow end facing towards the wheel.
Screw the adjustment nut onto the end of the
quick-release, next to the spring, by turning it
clockwise. Only 2 to 3 turns are required, leaving
a gap to slot the front wheel onto the forks.
Note the direction of rotation marked on the tyre
should be the same as on the rear wheel. Align
the front wheel with the fork holders and slot in
place, ensuring that the wheel ts tight within the
fork holders.
While holding the quick-release lever in line with
the wheel hub tighten the adjustment nut on
the opposite side by turning it clockwise until
resistance is felt.
To Next Page
Loading...