Carefully turn your eBike upright (the rear wheel
will not be fully secure) and locate the tension
marker on the frame of your eBike.
Push down on the belt directly above the tension
marker with your index nger. Make sure that
there is 1cm of movement when you push on
the belt.
Keep the rear wheel in this position and tighten
the belt tension adjuster screw that is on the
same side as the drive belt and sprockets.
To align the rear wheel with the frame, tighten the
other belt tension adjuster screw, located on the
opposite side. You might need to adjust the rst
screw again before the wheels line up.
Make sure that you do not tighten the belt too much as this will make it hard to pedal.
To Next Page
Loading...