Guldmann GH3 - Using Swing Kit in Doorway

A B
A B
A B
A B
A B
15
© Guldmann GB/US-02/2021 • # 550216_19
© Guldmann GB/US-02/2021 • # 550216_19
1.13 Using swing kit in doorway
1. Bring the two hoists as close together as
possible. Adjust the height of the lifting
hanger on hoist B so that the transfer can
be done without the user touching the
oor during the transfer from one hoist to
another.
2. Take the free lifting strap from hoist A
and secure it to the swing adapter on the
lifting hanger (see 1.10 gures 5 and 6).
In order to lower the free lifting strap on
hoist A a slight pull must be applied to the
strap.
3. Lower the lifting hanger using hoist B
while lifting the strap on hoist A to perform
the swing transfer. The transfer has been
completed when there is no load on the
lifting strap on hoist B.
4. Disconnect the lifting strap on hoist B
from the lifting hanger and raise the strap
on hoist B out of the way.
5. Move the lifting hanger from hoist A to
operating height and the doorway transfer
is complete.