Guldmann GH3 - CLM Module Data Tracking

39
© Guldmann GB/US-02/2021 • # 550216_19
© Guldmann GB/US-02/2021 • # 550216_19
2.11 CLM module (GH3+ with statistical function for management use)
The GH3+ with CLM module (option) includes a management tool that saves
important information on the use of the lifting module and which can be used
to evaluate the system’s e󰀩ciency and utilisation, as well as to optimise
its use and hoist name/location.
The following data can be shown on the hand control’s display: number of
lifts, number of heavy lifts, number of lifts in last week, average number of
lifts per week.
As an additional option, by connecting a PDA/Net Book to the hand control it
is possible to gain access to a number of other saved data, e.g. the number
of lifts since the last strap change, number of critically low battery readings,
number of weighings, total lifting time, etc.
This information can be downloaded and used for further analysis.
(PDA/Net Book readouts requires a PDA/Net Book with Guldmann SIC/CLM
software).
The USB in the hand control is only intended for connection of PDA/Net Book
and may only be used by Guldmann service team or by a Guldmann authori-
zed person.
Number of lifts, total A lift is registered automatically when the following
events are registered simultaneously
• Hand control is activated
(Direction UP) for more than 2 seconds
• The load on the lifting strap is registered being
heavier than: 15 kg (33 lbs)
Total includes the number of lifts performed after
the lifting module was first taken into use.
Number of heavy lifts, total A heavy lift is registered automatically when the
following events are registered simultaneously
• Hand control is activated (Direction UP) for
more than 2 seconds
• The load on the lifting strap is registered being
heavier than: 150 kg (330 lbs)
Total includes the number of heavy lifts performed
after the lifting module was first taken into use.
Number of lifts, last week The total number of lifts performed within the last
seven calendar days
Average number of lifts per
week
Average number of lifts per week (performed after
the lifting module was first taken into use or reset by
the Guldmann SIC/CLM software)
The data for “Number of lifts, last week” and “Average number of lifts
per week” can, if necessary, be reset using a PDA/Net Book.