GW Instek GDM-9060 - Page 311

REMOTE CONTROL
311
[SENSe:]PERiod:CURRent:RANGe
Sets the frequency measurement range.
Parameter: Range(<NRf> | MIN | MAX | DEF)
Example: SENS:PER:CURR:RANG MAX
Sets the period to the maximum range.
[SENSe:]PERiod:CURRent:RANGe?
Returns the period measurement range.
[SENSe:]PERiod:CURRent:RANGe:AUTO
Sets the Period Auto-range settings on, off or once.
Parameter: 0 | 1 | ON | OFF | ONCE
Example: SENS:PER:CURR:RANG:AUTO OFF
Turns the Auto-range setting off for period measurement.
[SENSe:]PERiod:CURRent:RANGe:AUTO?
Returns the Period Auto-range setting.
Return parameter: 0 | 1, 0=OFF, 1=ON
[SENSe:]PERiod:INPutjack
Assigns an input port for the period function.
Parameter: <NR1> (0 | 1 | 2), 0=Voltage, 1=3A, 2=10A
Example: SENS:PER:INP 1
Sets the input jack to the current 3A input port.
[SENSe:]PERiod:INPutjack?
Returns the assigned input port used for the period function.
Return parameter: VOLT | 3A | 10A
[SENSe:]PERiod:NULL[:STATe]
Sets the relative function on/off for Period measurement.
Parameter: 0 | 1 | ON | OFF
Example: SENS:PER:NULL:STAT ON
Turns the relative function on for Period measurement.
[SENSe:]PERiod:NULL[:STATe]?
Returns the relative function state of Period measurement.
Return parameter: 0 | 1, 0=OFF, 1=ON
[SENSe:]PERiod:NULL:VALue
Sets the relative value for Period measurement.
Parameter: <NRf> (-1.2~1.2 s) | MIN | MAX | DEF
Example: SENS:FREQ:NULL:VAL 1
Sets the relative value to 1s for Period measurement.
[SENSe:]PERiod:NULL:VALue?
Returns the current relative value of Period measurement.
w ww. . com
information@itm.com1.800.561.8187