GDM-906X Series User Manual
64
Thermistor 2W/4W Setting
The GDM-9060/9061 supports 2 or 4 wire Thermistor. It is
important to specify the type of temperature sensor used.
1. Press the F1 (Probe) key to enter the Temperature
Probe menu followed by clicking either the F4 (Therm2W)
or F5 (Therm4W) key to activate
Therm 2W/4W mode. See the figure shown below.
2. Press the F5 (Type) key to enter the Sensor Type
menu as the figure shown below. Click the F1 – F3 key to
select a desired sensor type per your requirement.
3. The display shows the latest setting. See the example of the
figure below where Thermistor 2W: 10kΩ is currently
activated by user.
Probe: Therm2W
Type: 10kΩ
Temperature
Measurement
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
