GDM-906X Series User Manual
338
*PSC?
Returns power on clear status.
Return parameter: <Boolean>(0|1) 0= disables, 1= enables
*RCL
Load the system parameters from 1 of 5 memory locations.
Parameter: <NR1> (0~4) (1~5= memory number)
Example: *RCL 1
Loads the memory 2 system parameters.
Note: prior to loading memory, the corresponding memory data is required;
otherwise, invalid data will be loaded and therefore command error will be shown.
*RST
Recalls default panel setup.
●Resets instrument to factory default state. This is similar to
SYSTem:PRESet. The difference is that *RST resets the instrument for SCPI
operation, and SYSTem:PRESet resets the instrument for front panel
operation. As a result, *RST turns the histogram and statistics off, and
SYSTem:PRESet turns them on.
*SAV
Save the system parameters to 1 of 5 memory locations.
Parameter: <NR1> (0~4) (1~5= memory number)
Example: *SAV 2
Saves the system parameters to memory 3.
*SRE?
Returns the SRER (Service Request Enable Register) contents.
*SRE
Sets SRER contents.
Parameter: <NR1>(0~255)
Example: *SRE 7
Sets the SRER to 00000111.
●An enable register defines which bits in the event register will be reported
to the Status Byte register group. You can write to or read from an enable
register.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
