GW Instek GPP-2323 - Page 101

REMOTE CONTROL
101
Select USB port in the Interface after
connecting the USB cable. The message USB
will appear gray in the status bar when
connection, and turns to white color while the
first command connects succesfully.
The front panel keys are automatically locked
when the connection is successful.
Parameter Setting
Press the System button followed by pressing
the F1 (Interface) button to select the target
port: F2 (USB). The setting of baud rate will
appear automatically, please then choose
desired setting.
Display
The parameter information of USB will appear
on LCD. Refer to the description below:
115200----> transmission baud rate
Function Check
Perform the following query:
*IDN?
The unit will return the manufacturer, model,
serial number and software version.
GW INSTEK, GPP-2323, SN: xxxxxxxxx, Vx.xx
Disabling Remote
Control Mode
 Send a remote command from the PC
 Long-press the F6 (unlock) key on the front
panel.
 Unplug the USB cable from the rear panel.
Note
USB devices are hot-plug devices. You can
directly remove the cable and exit.